Land Cruiser URJ200 URJ202 GRJ200 VDJ200 1GR-FE FUEL

The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

Install 2 new gaskets and the 2 straight screw plugs.

Using an E7 "TORX" wrench, replace the stud bolts labeled A shown in the illustration below.

Visually check the cylinder for vertical scratches.

If necessary, replace the cylinder block.

Using a dial indicator, measure the thrust clearance while moving the connecting rod back and forth.

• Standard thrust clearance:
• 0.14 to 0.54 mm (0.00551 to 0.0213 in.)

• Maximum thrust clearance:
• 0.60 mm (0.0236 in.)

If the thrust clearance is more than the maximum, replace one or more connecting rods as necessary.

Land Cruiser URJ200 URJ202 GRJ200 VDJ200 1VD-FTV ENGINE MECHANICAL

Using a 90° cutter, resurface the valve seat so that the valve seat width is more than the specification.

Install a new gasket with the No. 1 straight screw plug.

Gradually heat the cylinder head to 80 to 100°C (176 to 212°F).