Power Point Socket -- Removal |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE SWITCH BASE |
 |
Detach the 8 claws.
Disconnect all connectors and remove the switch base.
| 3. REMOVE POWER POINT SOCKET ASSEMBLY |
 |
Rotate the socket to disengage the notch.
Pull out the socket halfway and rotate the socket until its protrusion is aligned with the groove of the cover.
 |
Remove the socket from the cover.
| 4. REMOVE BACK DOOR SCUFF PLATE |
Using a screwdriver, detach the 4 claws.
- HINT:
- Tape the screwdriver tip before use.
 |
Using a clip remover, detach the 6 clips and remove the scuff plate.
| 5. REMOVE REAR DOOR SCUFF PLATE LH |
Using a screwdriver, detach the 7 claws.
- HINT:
- Tape the screwdriver tip before use.
 |
Using a clip remover, detach the 2 clips and remove the scuff plate.
| 6. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH |
| 7. REMOVE QUARTER INSIDE TRIM BOARD LH |
Disconnect the rear No. 1 seat belt outer anchor.
Detach the 2 claws and remove the lap belt outer anchor cover.
Remove the bolt and disconnect the anchor.
 |
Disconnect the rear No. 2 seat belt outer anchor.
Detach the 2 claws and remove the lap belt outer anchor cover.
Remove the bolt and disconnect the anchor.
Remove the screw and quarter trim hook.
Using a clip remover, remove the clip labeled A.
 |
Using a screwdriver, detach the 6 claws.
- HINT:
- Tape the screwdriver tip before use.
Using a clip remover, detach the 10 clips and remove the trim board.
Disconnect the cooler control switch connector.
Remove the 2 belt hangers.
| 8. REMOVE REAR POWER POINT SOCKET ASSEMBLY |
 |
Detach the 2 claw fittings and remove the socket.