Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - EXTERIOR PANELS / TRIM
FRONT BUMPER (w/ Winch) - REMOVAL
| 1. PRECAUTION |
- NOTICE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work ().
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for HID Headlight) |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().
| 3. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH |
Remove the 3 bolts and screw.
Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly LH.
| 4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH |
Remove the 3 bolts and 2 screws.
Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly RH.
| 5. REMOVE UPPER RADIATOR SUPPORT SEAL |
Remove the 7 clips and radiator support seal.
| 6. REMOVE FRONT BUMPER WINCH COVER SUB-ASSEMBLY |
Detach the 2 claws.
Detach the 3 guides and remove front bumper winch cover sub-assembly.
| 7. REMOVE RADIATOR GRILLE ASSEMBLY |
Put protective tape around the radiator grille assembly.
| *1 | Protective Tape |
Remove the 3 screws.
Detach the 2 clips and 8 claws, and remove the radiator grille assembly.
w/ Wide View Front Monitor System:
Disconnect the connector.
| 8. REMOVE FRONT BUMPER COVER |
Put protective tape around the bumper cover.
| *1 | Protective Tape | - | - |
Using a T30 "TORX" socket, remove the 6 screws.
| *A | LH Side | *B | RH Side |
Remove the 3 clips, 4 screws and 4 bolts.
Detach the 10 claws.
Disconnect the winch control wire connector and remove the front bumper cover.
w/ Fog Light:
Disconnect the No. 4 engine room wire connector and remove the front bumper cover.
| 9. REMOVE FRONT BUMPER EXTENSION LH |
Remove the 3 bolts and front bumper extension LH.
| 10. REMOVE FRONT BUMPER EXTENSION RH |
- HINT:
- Use the same procedure described for the LH side.
| 11. REMOVE FRONT BUMPER SIDE SUPPORT LH |
Remove the 2 screws.
Detach the 3 clips and remove the front bumper side support LH.
| 12. REMOVE FRONT BUMPER SIDE SUPPORT RH |
- HINT:
- Use the same procedure described for the LH side.
| 13. REMOVE HEADLIGHT ASSEMBLY LH |
for Halogen Headlight:
()
for HID Headlight:
()
| 14. REMOVE HEADLIGHT ASSEMBLY RH |
- HINT:
- Use the same procedure described for the LH side.
| 15. REMOVE FRONT UPPER CENTER BUMPER RETAINER |
Remove the 3 bolts and front upper center bumper retainer.