Lexus IS250 IS220d GSE20 ALE20 - ENGINE IMMOBILISER


ENGINE IMMOBILISER SYSTEM (for 4GR-FSE) - HOW TO PROCEED WITH TROUBLESHOOTING

  • HINT:
Use these procedures to troubleshoot the engine immobiliser system.
The intelligent tester should be used in steps 3, 4 and 6.

1.VEHICLE BROUGHT TO WORKSHOP
NEXT
2.CRANK ENGINE FOR MORE THAN 10 SECONDS
NEXT
3.INSPECT COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (BEAN)

Use the intelligent tester to check for normal function of the multiplex communication system (BEAN).


(ECU connected, communication line malfunctioning) Without code outputs, proceed to A.

(ECU connected, communication line malfunctioning) With code outputs, proceed to B.

B.
Go to MULTIPLEX COMMUNICATION SECTION
A
4.CHECK FOR DTC

Check for DTCs and note any codes that are output .

Delete the DTC.

Recheck for DTCs. Based on the DTCs output above, try to duplicate the SFI system DTC or engine immobiliser system DTC by simulating the symptoms indicated by the DTC.

  • Result:
  • ResultProceed to
    DTC output does not reoccurA
    SFI system DTC output reoccursB
    Engine immobiliser system DTC output reoccursC
B.
Go to SFI SYSTEM
C.
Go to DTC CHART
A
5.PROBLEM SYMPTOMS TABLE

If the fault is not listed in the problem symptoms table, proceed to A.

If the fault is listed in the problem symptoms table, proceed to B.

B.
Go to step 7
A
6.OVERALL ANALYSIS AND TROUBLESHOOTING

DATA LIST/ACTIVE TEST .

Terminals of ECU .

NEXT
7.ADJUST, REPAIR OR REPLACE
NEXT
8.CONFIRMATION TEST
NEXT
END
LEXUS IS250, IS220d / GSE20 ALE20
ENGINE IMMOBILISER
Lexus IS250 IS220d GSE20 ALE20
ENGINE IMMOBILISER SYSTEM for 4GR-FSE