REMOVE COOL AIR INTAKE DUCT SEAL

REMOVE FRONT BUMPER ASSEMBLY

REMOVE HEADLIGHT CLEANER WASHER NOZZLE

REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY

Remove the 11 clips and intake duct seal.

Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.

• HINT:

Put protective tape around the front bumper assembly.

Using a clip remover, remove the 2 clips

Remove the 2 radiator grille protectors.

Remove the bolt and 10 screws.

Disengage the 5 claws and disconnect the front bumper assembly as shown in the illustration.

• HINT:

• Use the same procedures for the RH side and LH side.

Disconnect the headlight washer hose. (w/ headlight cleaner system)

Disconnect the connector and remove the front bumper assembly.

Extend the headlight cleaner washer nozzle.

Remove the headlight cleaner washer nozzle.

• HINT:

• Use the same procedures for the RH side and the LH side.

Disconnect the headlight washer hose.

Remove the bolt.

Disengage the 2 claws and remove the headlight washer actuator sub-assembly as shown in the illustration.

• HINT:

• Use the same procedures for the RH side and the LH side.