REMOVE OIL FILTER ELEMENT SERVICE HOLE COVER

REMOVE ENGINE OIL

REMOVE OIL FILTER CAP ASSEMBLY

REMOVE OIL FILTER ELEMENT

INSTALL OIL FILTER ELEMENT

INSTALL OIL FILTER CAP ASSEMBLY

ADD ENGINE OIL

CHECK FOR ENGINE OIL LEAKS

CHECK ENGINE OIL LEVEL

INSTALL OIL FILTER ELEMENT SERVICE HOLE COVER

Remove the 3 screws from the oil filter element service hole cover.

Remove the oil pan drain plug and gasket, and drain the engine oil into a container.

Using SST, remove the oil filter cap assembly.

• SST
• 09228-06501

• HINT:

• Use a container to catch the draining oil. After the oil filter cap is loosened approximately 4 turns and the cap ribs are vertical, engine oil drains from the gap between the oil filter cap and oil pan.

Remove the oil filter element and the O-ring from the oil filter cap assembly.

Clean the inside of the oil filter cap assembly, the threads and O-ring groove.

Apply a small amount of engine oil to a new O-ring and install it to the oil filter cap assembly.

Set a new oil filter element in the oil filter cap assembly.

Remove any dirt or foreign matter from the installation surface of the engine.

Apply a small amount of engine oil to the O-ring again.

Using SST, tighten the oil filter cap assembly.

• SST
• 09228-06501

• Torque:
• 40 N*m{ 408 kgf*cm, 30 ft.*lbf}

• NOTICE:

• Check and clean the oil filter installation surface.

Install the oil pan drain plug with a new gasket.

• Torque:
• 38 N*m{ 388 kgf*cm, 28 ft.*lbf}

Add engine oil according to the table below.

• Standard capacity:

• Item	Capacity
  Drain and refill with oil filter change	6.0 liters (6.3 US qts, 5.3 lmp. qts)
  Drain and refill without oil filter change	5.2 liters (5.5 US qts, 4.6 lmp. qts)
  Dry fill	6.7 liters (7.1 US qts, 5.9 lmp. qts)

Start the engine. Make sure that there are no oil leaks from the connection point of the oil filter cap assembly.

Install the oil filter element service hole cover with the 3 screws.