REMOVE COOL AIR INTAKE DUCT SEAL

REMOVE NO. 1 INLET AIR CLEANER

REMOVE NO. 1 ENGINE COVER

REMOVE V-RIBBED BELT

REMOVE RADIATOR ASSEMBLY

REMOVE CRANKSHAFT PULLEY

REMOVE TIMING CHAIN CASE OIL SEAL

Remove the 11 clips and intake duct seal.

Remove the bolt, clip and inlet air cleaner.

Remove the No. 1 engine cover.

Release the belt tension by turning the belt tensioner counterclockwise, and remove the V-ribbed belt from the belt tensioner.

While turning the belt tensioner counterclockwise, align its holes, and then insert a 5 mm (0.20 in.) bar into the holes to hold the belt tensioner.

Remove the bolt while holding the crankshaft with SST.

• SST
• 09213-58013
  09330-00021

• Recommended service bolt:

• Item	Specified Condition
  Thread diameter	12 mm (0.47 in.)
  Thread pitch	1.5 mm (0.059 in.)
  Bolt length	Approx. 30 to 38 mm (1.18 to 1.50 in.)

Remove the crankshaft pulley with SST.

• SST
• 09950-50013(09951-05010,09952-05010,09953-05020,09954-05021)

Using a knife, cut off the oil seal lip.

Using a screwdriver with the tip taped, pry out the oil seal.

• HINT:

• Tape the screwdriver tip before use.

• NOTICE:

• After removing the oil seal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.