Cruise Control System Tc And Cg Terminal Circuit
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK HARNESS AND CONNECTOR (DLC3 - ECM AND BODY GROUND)
CRUISE CONTROL SYSTEM - TC and CG Terminal Circuit |
DESCRIPTION
Connecting terminals TC and CG of the DLC3 causes the system to enter self-diagnostic mode. If a malfunction is present, DTCs will be output.- HINT:
- When a particular warning light remains blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in the relevant ECU is suspected.
WIRING DIAGRAM
INSPECTION PROCEDURE
1.CHECK HARNESS AND CONNECTOR (DLC3 - ECM AND BODY GROUND) |
Disconnect the A38*1 or A52*2 ECM connector.
- HINT:
- *1: for LHD
- *2: for RHD
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
for 1GR-FE LHD, 1UR-FE LHD, 3UR-FE LHDTester Connection
| Condition
| Specified Condition
|
E22-13 (TC) - A38-16 (TC)
| Always
| Below 1 Ω
|
E22-4 (CG) - Body ground
|
E22-13 (TC) - Body ground
| Always
| 10 kΩ or higher
|
for 1GR-FE RHD, 1UR-FE RHDTester Connection
| Condition
| Specified Condition
|
E22-13 (TC) - A52-16 (TC)
| Always
| Below 1 Ω
|
E22-4 (CG) - Body ground
|
E22-13 (TC) - Body ground
| Always
| 10 kΩ or higher
|
for 1VD-FTV LHDTester Connection
| Condition
| Specified Condition
|
E22-13 (TC) - A38-27 (TC)
| Always
| Below 1 Ω
|
E22-4 (CG) - Body ground
|
E22-13 (TC) - Body ground
| Always
| 10 kΩ or higher
|
for 1VD-FTV RHDTester Connection
| Condition
| Specified Condition
|
E22-13 (TC) - A52-27 (TC)
| Always
| Below 1 Ω
|
E22-4 (CG) - Body ground
|
E22-13 (TC) - Body ground
| Always
| 10 kΩ or higher
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
OK |
|
|
|
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here) |
|