Camshaft position sensor 2AD-FHV
Components
Camshaft position sensor 2AD-FHV
Removal
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
-
Detach the 4 clips and remove the engine cover.
-
Remove the 2 bolts and reservoir.
-
Remove the bolt and bracket.
-
Disconnect the sensor connector.
-
Remove the bolt and sensor.
Camshaft position sensor 2AD-FHV
Inspection
-
Measure the resistance between the terminals.
Standard resistance:
Temperature Specified Condition Cold 835 to 1,400 ? Hot 1,060 to 1,645 ? NOTICE:
In the table above, the terms "Cold" and "Hot" refer to the temperature of the coils. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).
If the resistance is not as specified, replace the sensor.
Camshaft position sensor 2AD-FHV
Installation
-
Apply a light coat of engine oil to the O-ring of the sensor.
-
Install the sensor with the bolt.
Момент затяжки:
8.8 Н*м{ 90 кгс*см , 78 фунт-сила-дюймов }
-
Connect the sensor connector.
-
Install the bracket with the bolt.
Момент затяжки:
5.0 Н*м{ 51 кгс*см , 44 фунт-сила-дюймов }
-
Install the reservoir with the 2 bolts.
Момент затяжки:
5.0 Н*м{ 51 кгс*см , 44 фунт-сила-дюймов }
-
Attach the 4 clips to install the engine cover.