Dtc C1379 Downhill Assist Control Switch Malfunction (Test Mode Dtc)

Brake. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35
Brake Control. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

READ VALUE USING INTELLIGENT TESTER (DOWNHILL ASSIST CONTROL SWITCH)

PERFORM TEST MODE (SIGNAL CHECK)

INSPECT DOWNHILL ASSIST CONTROL SWITCH

CHECK HARNESS AND CONNECTOR (DOWNHILL ASSIST CONTROL SW - SKID CONTROL ECU/BODY GROUND)

DTC C1379 Downhill Assist Control Switch Malfunction (Test Mode DTC)


DESCRIPTION

DTC C1379 will be cleared when the downhill assist control switch sends a downhill assist control operation signal or when Test Mode ends. DTC C1379 is stored only in Test Mode.

DTC Code
DTC Detection Condition
Trouble Area
C1379
Stored only during Test Mode.
Downhill assist control switch

WIRING DIAGRAM


Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35.Brake Control.Anti-Lock Brake System.
Dtc
  C1379  Downhill Assist Control Switch Malfunction (Test Mode Dtc)


INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (RAV4_ACA30 RM000001K1O00SX.html).
1.READ VALUE USING INTELLIGENT TESTER (DOWNHILL ASSIST CONTROL SWITCH)
  1. Check the Data List for proper functioning of the downhill assist control switch.

    ABS/VSC/TRC:
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Downhill Assist Control Switch
    Downhill assist control switch / ON or OFF
    ON: Downhill assist control switch is on
    OFF: Downhill assist control switch is off
    -
    OK:
    The intelligent tester displays ON or OFF according to downhill assist control switch operation.


NG
Go to step 3
OK


2.PERFORM TEST MODE (SIGNAL CHECK)
  1. Turn the ignition switch off.

  1. Perform the sensor check in the Test Mode procedure (RAV4_ACA30 RM0000022CZ007X.html).

    OK:
    All Test Mode DTCs are cleared.
    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (RAV4_ACA30 RM000000OS701UX.html).


NG
REPLACE BRAKE ACTUATOR ASSEMBLY (RAV4_ACA30 RM000001XV200PX.html)
OK

CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (RAV4_ACA30 RM00000135201PX.html)

3.INSPECT DOWNHILL ASSIST CONTROL SWITCH


    Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35.Brake Control.Anti-Lock Brake System.
Dtc
  C1379  Downhill Assist Control Switch Malfunction (Test Mode Dtc)
  1. Turn the ignition switch off.

  1. Make sure that there is no looseness in the locking part and connecting part of the connector.

  1. Disconnect the downhill assist control switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 4
    Switch is pushed
    Below 1 Ω
    Switch is not pushed
    10 kΩ or higher
    NOTICE:
    Check the downhill assist control switch signal after replacement (RAV4_ACA30 RM0000022CZ007X.html).


NG
REPLACE DOWNHILL ASSIST CONTROL SWITCH (RAV4_ACA30 RM000002101009X.html)
OK


4.CHECK HARNESS AND CONNECTOR (DOWNHILL ASSIST CONTROL SW - SKID CONTROL ECU/BODY GROUND)


    Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35.Brake Control.Anti-Lock Brake System.
Dtc
  C1379  Downhill Assist Control Switch Malfunction (Test Mode Dtc)
  1. Disconnect the skid control ECU connector.

  1. Disconnect the downhill assist control switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A67-29 (HDCS) - E36-4
    Always
    Below 1 Ω
    A67-29 (HDCS) - Body ground
    Always
    10 kΩ or higher
    E36-1 - Body ground
    Always
    Below 1 Ω
    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (RAV4_ACA30 RM000000OS701UX.html).


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (RAV4_ACA30 RM000001XV200PX.html)