Vehicle Stability Control System (For Vacuum Brake Booster) Diagnosis System

  1. DESCRIPTION

  1. DIAGNOSIS

  1. WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK

Vehicle Stability Control System (For Vacuum Brake Booster) -- Diagnosis System



DESCRIPTION
When troubleshooting a vehicle with the diagnosis system, the only difference from the usual troubleshooting procedure is connecting the intelligent tester to the vehicle and reading various data output from the vehicle's skid control ECU.
The skid control ECU stores DTCs when the ECU detects a malfunction in the ECU itself or in its circuits.
To check the DTCs, connect the intelligent tester to the DLC3 of the vehicle. The intelligent tester enables you to clear the DTCs, activate various actuators, and check the Freeze Frame Data and Data List.

  1. Check the battery voltage.

    Standard voltage:
    11 to 14 V
    If the voltage is below 11 V, recharge the battery before proceeding to the next step.

DIAGNOSIS

  1. If the skid control ECU detects a malfunction, the ABS warning light, slip indicator light and brake warning light come on in order to warn the driver.

  2. DTCs are simultaneously stored in memory. Output DTCs can be read by connecting SST to terminals 13 (TC) and 4 (CG) of the DLC3 and observing the blinking pattern of the ABS warning light and slip indicator light, or by connecting the intelligent tester (LandCruiser RM000000XHV0KEX.html).

    NOTICE:
    If parts connected to the IG terminal circuit are damaged due to high voltage, DTCs may not be able to be output from the ABS warning light and slip indicator light by connecting SST to the DLC3. In this case, inspect the IG power source circuit.

  3. This system has a test mode (signal check) function (LandCruiser RM000000XHT0EPX.html).


WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK

  1. Release the parking brake.

    NOTICE:
    When releasing the parking brake, move the shift lever to P (for Automatic Transmission) or set chocks (for Manual Transmission) to prevent the vehicle from rolling.
    HINT:
    When the parking brake is applied or the level of the brake fluid is low, the brake warning light comes on.

  2. When the ignition switch is turned to ON, check that the ABS warning light, brake warning light and slip indicator light come on for approximately 3 seconds.

    HINT:
    If the warning light and indicator light check result is not normal, proceed to troubleshooting for the ABS warning light, brake warning light and slip indicator light circuits.
    If an indicator remains on or does not come on, proceed to troubleshooting for the light circuits listed below.
    Trouble Area
    		See procedure
    ABS warning light circuit (Remains on)
    		LandCruiser RM000000XIH0KFX.html
    ABS warning light circuit (Does not come on)
    		LandCruiser RM000000XIQ0K7X.html
    Brake warning light circuit (Remains on)
    		LandCruiser RM000000YHG0KFX.html
    Brake warning light circuit (Does not come on)
    		LandCruiser RM000000YHH0K7X.html
    Slip indicator light circuit (Remains on)
    		LandCruiser RM000000YHI0FTX.html
    Slip indicator light circuit (Does not come on)
    		LandCruiser RM000000YHJ0FSX.html