Vehicle Stability Control System Ts And Cg Terminal Circuit
Brake. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DLC3)
CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)
VEHICLE STABILITY CONTROL SYSTEM - TS and CG Terminal Circuit |
DESCRIPTION
Sensor check mode can be entered by connecting terminals TS and CG of the DLC3 and turning the ignition switch from off to ON.
WIRING DIAGRAM
INSPECTION PROCEDURE
- NOTICE:
- After replacing the brake actuator assembly, perform calibration (HILUX_TGN26 RM000000XHR073X.html).
- Before disconnecting the connector, make sure that there are no problems with the connection.
- After disconnecting the connector, make sure that the connector case and terminals are not deformed or corroded.
| 1.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DLC3) |
Turn the ignition switch off.
Disconnect the skid control ECU (brake actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
A36-33 (TS) - G18-12 (TS)
| Always
| Below 1 Ω
|
A36-33 (TS) - Body ground
| Always
| 10 kΩ or higher
|
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| 2.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND) |
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
G18-4 (CG) - Body ground
| Always
| Below 1 Ω
|
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
