Skid Control Sensor Installation

Install the rear axle hub and bearing assembly with skid control sensor (CAMRY_ACV40 RM000001IXJ00XX_01_0001.html).

HINT:

1. The skid control sensor is a component of the rear axle hub and bearing assembly. If the skid control sensor needs to be replaced, replace the rear axle hub and bearing assembly.
   
2. If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.
   

Using a dial indicator, check for looseness near the center of the axle hub.

Maximum:

0.05 mm (0.0020 in.)

NOTICE:

Ensure that the dial indicator is set perpendicular to the measurement surface.

Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.

Maximum:

0.07 mm (0.0027 in.)

NOTICE:

Ensure that the dial indicator is set perpendicular to the measurement surface.

Aligning the matchmarks, install the rear disc.

HINT:

When replacing the rear disc with a new one, select the installation position where the rear disc has the minimum runout.

Install the rear disc brake caliper with the 2 bolts.

Torque:

62 N*m{630 kgf*cm, 46 ft.*lbf}

NOTICE:

Do not twist the brake hose when installing the rear disc brake caliper assembly LH.

Install the rear flexible hose with the bolt.

Torque:

19 N*m{192 kgf*cm, 14 ft.*lbf}

Connect the skid control sensor wire to the skid control sensor.