Intake Air Control System -- Precaution |
1.EXPRESSIONS OF IGNITION SWITCH |
- УКАЗАНИЕ:
- The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
Expression | Ignition Switch (position) | Engine Switch (condition) |
Ignition Switch off | LOCK | Off |
Ignition Switch on (IG) | ON | On (IG) |
Ignition Switch on (ACC) | ACC | On (ACC) |
Engine Start | START | Start |
2.MAINTENANCE PRECAUTION |
Do not stop the engine immediately after pulling a trailer, driving at a high speed, or uphill driving. Let the engine idle for 20 to 120 seconds before turning the ignition switch off. According to the driving condition, vary the idling time.
Avoid quick acceleration or quickly accelerating the engine rpm immediately after starting a cold engine.
If the turbocharger is found to be defective, it must be replaced. Also, inspect the source of the trouble including the conditions under which the turbocharger was used. Repair or replace the following as necessary:
Engine oil (level and quality)
Oil lines leading to the turbocharger
Be careful when removing and reinstalling the turbocharger assembly. Do not drop, give a shock, or grasp easily-deformed assembly parts such as the actuator or push rod during the removal and reinstallation.
Before removal, cover both the intake and exhaust ports and the oil inlet to prevent dirt or foreign objects from entering.
If replacing the turbocharger, check for deposits in the oil pipe. If necessary, replace the oil pipe too.
Thoroughly remove the old gasket sticking to the lubrication oil pipe flange and the turbocharger oil flange.
If replacing the bolts or nuts, use TOYOTA genuine parts to prevent breakage or deformation.
If replacing the turbocharger, put 20 cm3 (1.2 cu in.) of fresh oil into the turbocharger oil inlet hole and turn the turbine wheel by hand to spread oil to the bearing.
If overhauling or replacing the engine, cut the fuel supply after reassembly and crank the engine for 30 seconds to distribute oil throughout the engine. Then reconnect the fuel supply and allow the engine to idle for 60 seconds.
Since the turbine wheels run at an extremely high speed, if the engine is running without the air cleaner, case cover and hose, damage to the turbine wheel will result due to entry of foreign particles.
![]() |
![]() |
![]() |
![]() |