Контактный Датчик Давления Масла Установка

Clean the threads of the oil pressure switch and apply adhesive to them.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

ПРИМЕЧАНИЕ:

Do not apply adhesive to the oil inlet port of the oil pressure switch.

Using a 24 mm deep socket wrench, install the oil pressure switch.

Момент затяжки:

15 N*m{150 kgf*cm, 11 ft.*lbf}

ПРИМЕЧАНИЕ:

Do not start the engine within 1 hour of installation.

Connect the vacuum pump oil inlet hose with a new gasket and the union bolt.

Момент затяжки:

14 N*m{140 kgf*cm, 10 ft.*lbf}

УКАЗАНИЕ:

When tightening the inlet hose, hang the stopper-bar of the inlet hose on the filter bracket to prevent the inlet hose from rotating.

Apply a light coat of engine oil to a new O-ring.

Install the O-ring to the dipstick guide.

Install the dipstick guide with the 2 bolts.

Момент затяжки:

18 N*m{184 kgf*cm, 13 ft.*lbf}

Install the dipstick.

Disconnect the sensor connector.

Detach the wire harness clamp.

Loosen the hose clamp and remove the resonator with air cleaner cap.

Detach the 4 hook clamps, and then remove the air cleaner cap and resonator with air cleaner cap.

Start the engine. Make sure that there are no oil leaks from the areas that were worked on.