Свеча Накаливания Снятие

Двигатель Гибридная Система Land Cruiser Prado.
Система Запуска Двигателя 5L-E.

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE RESONATOR WITH AIR CLEANER CAP SUB-ASSEMBLY

  3. REMOVE INTAKE PIPE

  4. DISCONNECT VENTILATION HOSE

  5. REMOVE NO. 1 GLOW PLUG CONNECTOR

  6. REMOVE GLOW PLUG ASSEMBLY

Свеча Накаливания -- Снятие



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
ПРИМЕЧАНИЕ:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page Нажмите здесь).
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page Нажмите здесь).


2. REMOVE RESONATOR WITH AIR CLEANER CAP SUB-ASSEMBLY



  1. Disconnect the sensor connector.

  1. Detach the wire harness clamp.

  1. Loosen the hose clamp and remove the resonator with air cleaner cap.




  1. Detach the 4 hook clamps, and then remove the air cleaner cap and resonator with air cleaner cap.



3. REMOVE INTAKE PIPE



  1. Remove the 2 bolts.

  1. Loosen the hose clamp and remove the intake pipe.



4. DISCONNECT VENTILATION HOSE



  1. Disconnect the ventilation hose.



5. REMOVE NO. 1 GLOW PLUG CONNECTOR



  1. Remove the nut, No. 2 glow plug resistor insulator and washer and disconnect the wire harness.

  1. Remove the 4 screw grommets and 4 nuts.

  1. Remove the No. 1 glow plug connector and No. 1 glow plug resistor insulator.



6. REMOVE GLOW PLUG ASSEMBLY



  1. Using a 12 mm deep socket wrench, remove the 4 glow plugs.