Датчик Абсолютного Давления В Коллекторе Проверка Без Снятия С Автомобиля. Corolla Auris

Двигатель. COROLLA, AURIS. ZZE150 ZRE151,152 NDE150
Система Управления Двигателем 2Ad-Fhv. COROLLA, AURIS. ZZE150 ZRE151,152 NDE150

  1. CHECK MANIFOLD ABSOLUTE PRESSURE SENSOR

Датчик Абсолютного Давления В Коллекторе -- Проверка Без Снятия С Автомобиля



1. CHECK MANIFOLD ABSOLUTE PRESSURE SENSOR


    COROLLA, AURIS. ZZE150 ZRE151,152 NDE150.Система Управления Двигателем 2Ad-Fhv.Система Ecd.Датчик Абсолютного Давления В Коллекторе Проверка Без Снятия С Автомобиля

  1. Inspect the power source voltage.

    1. Disconnect the manifold absolute pressure sensor connector.

    2. Turn the ignition switch on (IG).

    3. Using an voltmeter, measure the voltage according to the value(s) in the table below.

      Standard voltage:
      Tester Connection
      		Condition
      		Specified Condition
      3 (VC) - 1 (E2)
      		Always
      		4.5 to 5.5 V
      If the result is not as specified, check the harness and connector (See page Нажмите здесь).

    4. Turn the ignition switch off.

    5. Reconnect the manifold absolute pressure sensor connector.

  1. Check the vacuum and pressure.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG) and turn the tester on.

    3. Enter the following menus: Powertrain / Engine and ECT / Data List / Map and Atmosphere Pressure.

    4. Read the value.

      Standard vacuum and pressure:
      Condition
      		Map Value
      No pressure applied
      		Same as atmospheric pressure
      Vacuum applied
      		Becomes vacuum
      Pressure applied
      		Becomes pressurized
      If the result is not as specified, replace the manifold absolute pressure sensor.