Трос Механизма Переключения Передач (Для Моделей Производства Тмс С Кузовом Типа "Хэтчбэк") -- Регулировка |
1. ADJUST TRANSMISSION CONTROL SELECT CABLE |
- УКАЗАНИЕ:
- After the shift lever or the shift cable is replaced, be sure to adjust the transmission control cable assembly.
- If the shift lever does not move (or the shift lever is difficult to move) to the 1st or 2nd position, or if it is possible to move the shift lever to the reverse position without pulling up the slider shaft, the length of the cable must be adjusted.
Install the transmission control cable assembly to the manual transaxle.
Release the lock of the cable length adjustment structure of the select cable.
Slide the preventive part (slider) of lock release.
Release the lock of the cable length adjustment structure to push out the lock piece from the case.
![]() |
Install the transmission control cable assembly to the shift lever assembly.
Pressing the shift and select lever shaft (*1) and pin (*2), push in pin (*3) and check that the shift and select lever shaft is secured at the 1st-2nd gear selected position (the shaft comes to a stop at the position 8 mm (0.31 in.) below the N position).
Remove the stopper pin, release the lock, and reinsert the stopper pin.
![]() |
Turn the shift lever in the reverse direction without pulling up the slider shaft.
- ПРИМЕЧАНИЕ:
- When adjusting the cable, make sure that the shift lever is not in the first or second gear position.
![]() |
Lock the cable length adjustment structure of the select cable.
- ПРИМЕЧАНИЕ:
- Push the lock piece as far as it will go.
- Confirm whether the cable length adjustment structure is locked surely.
Release the pin that fixes the transmission outer lever.
Pull the pin toward the front left side of the vehicle.
![]() |