Блок Двигателя Замена. Corolla Auris

Using "TORX" socket wrench E5, remove the 4 stud bolts.

Using "TORX" socket wrench E5, install the 4 stud bolts.

Момент затяжки:

5.0 Н*м{51 кгс*см, 44 фунт-сила-дюймов}

Using a screwdriver with its tip wrapped in protective tape, remove the oil pump seal.

Using SST and a hammer, tap in the new oil seal until its surface is flush with the oil pump edge.

ПРИМЕЧАНИЕ:

Tap the oil seal in from a vertical position.

Apply MP grease to a new oil seal lip.

ПРИМЕЧАНИЕ:

Keep the lip free of foreign matter.

Using a knife, cut off the oil seal lip.

Using a screwdriver with its tip wrapped in tape, pry out the oil seal.

ПРИМЕЧАНИЕ:

After removing, check the crankshaft for any damage. If damaged, smooth the surface with 400-grit sandpaper.

Apply MP grease to a new oil seal lip.

ПРИМЕЧАНИЕ:

Keep the lip free of foreign matter.

Using SST and a hammer, tap in the new oil seal until its surface is flush with the cylinder block edge.

ПРИМЕЧАНИЕ:

1. Tap the oil seal from the vertical position.
   
2. Wipe any extra grease off the crankshaft.