Интегрированное Реле Снятие. Corolla Auris

Remove the 2 nuts.

Disconnect the 3 wire harness connectors.

Detach the 2 claws and disconnect the wire harness.

Detach the 4 clips and remove the engine cover.

ПРИМЕЧАНИЕ:

1. Lift the area around the clips on the top of the engine cover.
   
2. Do not suddenly lift the engine cover. Remove the cover slowly by detaching the clips on by one.
   
3. Lift area A shown in the illustration particularly slowly because there is a cowl on the top of the area around A. Failure to do so may damage the cover.
   

Disconnect the mass air flow meter connector.

Disconnect the No. 2 ventilation hose.

Disconnect the 2 clamps and band, and remove the air cleaner cap sub-assembly.

Remove the air cleaner filter element.

Remove the 3 bolts and air cleaner case.

Disconnect the 2 ECM connectors.

1. Raise the 2 levers while pushing the locks on the levers, and disconnect the 2 ECM connectors.
   

   ПРИМЕЧАНИЕ:

   After disconnecting the connectors, make sure that dirt, water, or other foreign matter does not contact the connecting parts of the connectors.

Remove the 2 bolts from the ECM.

Remove the 4 screws and ECM bracket.

Using a screwdriver, turn the clip 90° and remove it.

Remove the 4 clips and turn over the front liner LH.

Disconnect the 2 wire harness clamps.

Remove the 3 bolts.

Disengage the claw and guide and slide the relay block to the inside of the engine compartment.

ПРИМЕЧАНИЕ:

Do not forcibly pull the relay block as the wire harness is connected.

Disengage the 10 claws and separate the relay block cover into the upper side and lower side.

Disengage the 4 claws of the fuse holder and fusible link block assembly, and pull out the fuse holder and fusible link block assembly as a unit from the separated relay block cover.

ПРИМЕЧАНИЕ:

Do not forcibly pull the relay block as the wire harness is connected.

Remove the bolt.

Disengage the claw and disconnect the fuse holder from the fusible link block assembly.

Remove the 2 bolts and disconnect the 2 wire harnesses.

ПРИМЕЧАНИЕ:

When disconnecting the wire harness from the fusible link block assembly, mark the fusible link block assembly, wire harness and bolt to prevent mistakes when reconnecting.

Remove the 3 bolts and disconnect the 3 wire harnesses.

ПРИМЕЧАНИЕ:

When disconnecting the wire harness from the fusible link block assembly, mark the fusible link block assembly, wire harness, connector and bolt to prevent mistakes when reconnecting.

Disconnect the 2 connectors and remove the fusible link block assembly.

Disconnect the 3 connectors.

Disengage the 2 claws and remove the integration relay.