Датчик Абсолютного Давления В Коллекторе Проверка Без Снятия С Автомобиля. Corolla Auris

Двигатель. COROLLA, AURIS. ZZE150 ZRE151,152 NDE150
Система Управления Двигателем 1Ad-Ftv. COROLLA, AURIS. ZZE150 ZRE151,152 NDE150

  1. CHECK MANIFOLD ABSOLUTE PRESSURE SENSOR

Датчик Абсолютного Давления В Коллекторе -- Проверка Без Снятия С Автомобиля



1. CHECK MANIFOLD ABSOLUTE PRESSURE SENSOR


    COROLLA, AURIS. ZZE150 ZRE151,152 NDE150.Система Управления Двигателем 1Ad-Ftv.Система Ecd.Датчик Абсолютного Давления В Коллекторе Проверка Без Снятия С Автомобиля

  1. Inspect the power source voltage.

    1. Disconnect the manifold absolute pressure sensor connector.

    2. Turn the ignition switch on (IG).

    3. Using a voltmeter, measure the voltage between terminals 3 (VC) and 1 (E2) of the wiring harness side connector.

      Standard voltage:
      4.5 to 5.5 V

    4. Turn the ignition switch off.

    5. Reconnect the manifold absolute pressure sensor connector.

  1. Check the vacuum and pressure.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG) and turn the tester on.

    3. Enter the following menus: Powertrain / Engine and ECT / Data List / Map and Atmosphere Pressure.

    4. Read the value.

      OK:
      Condition
      		Map Value
      No pressure applied
      		Same as atmospheric pressure
      Vacuum applied
      		Becomes vacuum
      Pressure applied
      		Becomes pressurized
      If the result is not as specified, replace the manifold absolute pressure sensor.