Система Смазки Проверка Без Снятия С Автомобиля. Corolla Auris

Warm up the engine, then stop the engine and wait for 5 minutes.

Check that the engine oil level is between the low level and full level marks on the level gauge.
If low, check for leakage and add oil up to the full level mark.

ПРИМЕЧАНИЕ:

Do not fill with engine oil above the full level mark.

Check the oil for deterioration, entry of water, discoloring or thinning.
If the quality is visibly poor, replace the oil.

Disconnect the oil pressure switch connector.

Using a 24 mm deep socket wrench, remove the oil pressure switch.

Install the oil pressure gauge.

Warm up the engine.

Check the oil pressure. If the oil pressure is not as specified, check the oil pump (See page Нажмите здесь).

Oil pressure:

At Idle	At 3000 rpm
25 kPa (0.3 kgf/cm2, 3.6 psi) or more	150 to 550 kPa (1.5 to 5.6 kgf/cm2, 22 to 80 psi)

Apply adhesive to 2 or 3 threads of the oil pressure switch.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

Using a 24 mm deep socket wrench, install the oil pressure switch.

Момент затяжки:

15 Н*м{153 кгс*см, 11 фунт-сила-футов}

ПРИМЕЧАНИЕ:

Do not start the engine for at least 1 hour after installation.

Connect the oil pressure switch connector.

Check for engine oil leaks.