Трос Механизма Переключения Передач В Сборе (Для Моделей С Кузовом Типа Хэтчбэк) Регулировка. Corolla ZZE150

When moving the lever from the P position to the R position with the ignition switch on (IG) and the brake pedal depressed, make sure that the shift lever moves smoothly and moves correctly into position.

Start the engine and make sure that the vehicle moves forward when moving the lever from the N position to the D position and moves rearward when moving the lever to the R position. If the operation cannot be performed as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition.

Apply the parking brake and move the shift lever to the N position.

Remove the lower instrument panel finish panel (See page Нажмите здесь).

Disconnect the end of the transmission control cable assembly from the shift lever assembly.

Turn the lock nut counterclockwise. While holding the lock nut, disconnect the transmission control cable from the shift lever retainer.

Slide the slider of the transmission control cable in the direction indicated by the arrow and pull the lock piece outward.

Connect the outer part of the transmission control cable to the shift lever retainer.

УКАЗАНИЕ:

After installation, check that the outer part of the cable protrudes above the A-A line as shown in the illustration.

Install the transmission control cable end to the shift lever assembly.

ПРИМЕЧАНИЕ:

1. Check that the lock piece is pulled outward.
   
2. Install the cable end all the way to the base of the pin.
   

Push the lock piece into the adjuster case.

ПРИМЕЧАНИЕ:

Securely push in the lock piece until the slider lock is engaged.

After adjusting the shift lever position, check that the operation and function of the shift lever. If there is a problem, adjust the position again.

Install the lower instrument panel finish panel (See page Нажмите здесь).