Приводной Ремень Установка. Corolla Auris

Temporarily install the v-ribbed belt onto each pulley.

ПРИМЕЧАНИЕ:

1. Before installing the V belt, check each pulley for any kind of liquid and chips.
   

1. Check that the ribs of the V belt are correctly fitted into the grooves of the pulleys.
   

Insert a bar between the generator and the engine. Pull the bar toward the front of the vehicle and adjust the tension.

Tighten bolt A, then tighten bolt B.

Момент затяжки:

Bolt A:

19 Н*м{189 кгс*см, 14 фунт-сила-футов}

Bolt B:

32 Н*м{326 кгс*см, 24 фунт-сила-футов}

Inspect the v-ribbed belt deflection.

Pressing force:

98 N (10 kgf, 221 lbf)

Inspect the v-ribbed V belt tension.

ПРИМЕЧАНИЕ:

1. Check the V belt deflection at the specified point.
   

1. When installing a new belt, set its tension value as specified.
   

1. When checking a belt used for over 5 minutes, confirm that the deflection value is within the specified range for a used belt.
   

1. When reinstalling a belt used for over 5 minutes, check whether its deflection value is within the specified range for the used belt.
   

1. When using a belt tension gauge, confirm its accuracy first by using a master gauge.
   

Install the wire harness with the 3 bolts and 2 wire harness clamps.

Момент затяжки:

Bolt A:

13 Н*м{131 кгс*см, 14 фунт-сила-футов}

Bolt B:

11 Н*м{112 кгс*см, 8 фунт-сила-футов}

Install the engine under cover rear RH with the 5 clips.

Fit the 4 retainers and install the No. 1 engine cover.