Топливная Система Проверка Без Снятия С Автомобиля. Corolla Auris

Двигатель. COROLLA, AURIS. ZZE150 ZRE151,152 NDE150
Топливная Система 1Ad-Ftv. COROLLA, AURIS. ZZE150 ZRE151,152 NDE150

  1. FUEL PRESSURE

  2. INSPECT FOR FUEL LEAK

Топливная Система -- Проверка Без Снятия С Автомобиля



1. FUEL PRESSURE

  1. READ DATA LIST

    ПРИМЕЧАНИЕ:
    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
    УКАЗАНИЕ:
    Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    1. Warm up the engine.

    2. Turn the ignition switch off.

    3. Connect the intelligent tester to the DLC3.

    4. Turn the ignition switch on (IG).

    5. Turn the intelligent tester on.

    6. Enter the following menu items: Powertrain / Engine / Data List.

    7. Read the Data List.

      Tester Display
      		Measurement Item/Range
      		Normal Condition
      Fuel Press
      		Fuel pressure/
      Min.: 0 MPa, Max.: 655.350 MPa
      		Idling: 35 to 45 MPa
      Target Common Rail pressure
      		Target common rail pressure/
      Min.: 0 kPa, Max.: 655350 kPa
      		Idling: 35 to 45 MPa



2. INSPECT FOR FUEL LEAK
УКАЗАНИЕ:
Using the intelligent tester to perform Active Tests allow relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. PERFORM ACTIVE TEST

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Powertrain / Engine / Active Test.

    5. Perform the Active Test.

      Tester Display
      		Test Part
      		Control Range
      		Diagnostic Notes
      Test the Fuel Leak
      		Pressurizes common rail internal fuel pressure, and checks for fuel leaks
      		Stop/Start
      1. Fuel pressure inside common rail pressurized to specified value and engine speed increased to 2000 rpm when ON is selected
      2. Above conditions preserved while test is ON