Жгут Электропроводки Трансмиссии Снятие. Corolla ZZE150

Remove the drain plug and gasket, and drain ATF.

Install a new gasket and the drain plug.

Момент затяжки:

49 Н*м{500 кгс*см, 36 фунт-сила-футов}

Remove the 19 bolts and remove the oil pan and oil pan gasket.

ПРИМЕЧАНИЕ:

Some fluid will remain in the oil pan.

Remove all the oil pan bolts, and carefully remove the oil pan sub-assembly.

Remove the 2 magnets from the oil pan.

Examine the particles in the pan.

1. Collect any steel chips using the removed magnets.
   Carefully inspect the foreign matter and particles in the pan and on the magnets to see the type of wear which might be found in the transaxle.
   Steel (magnetic): bearing, gear and clutch plate wear
   Brass (non-magnetic): bearing wear
   

Remove the 3 bolts and remove the oil strainer.

ПРИМЕЧАНИЕ:

Perform the operation carefully as some fluid will come out from the oil strainer.

Remove the oil strainer gasket from the oil strainer.

Disconnect the 5 connectors.

Remove the bolt and lock plate and remove the ATF temperature sensor.

Remove the 2 bolts and remove the detent spring cover and detent spring.

Remove the 13 bolts and remove the valve body assembly.

ПРИМЕЧАНИЕ:

Do not drop the check ball body, check ball body spring or accumulator piston.

Remove the check ball body and check ball body spring.

Remove the 2 transaxle case 2nd brake gaskets.

Remove the bolt and the transmission wire from the transaxle case.

Remove the O-ring from the transmission wire.