Стартер Установка. Corolla Auris

Install the starter assembly with the 2 bolts.

Момент затяжки:

64 Н*м{653 кгс*см, 47 фунт-сила-футов}

Install the wire harness with the nut.

Момент затяжки:

9.8 Н*м{100 кгс*см, 87 фунт-сила-дюймов}

Connect the starter connector.

Install the bracket with the bolt.

Момент затяжки:

26 Н*м{260 кгс*см, 19 фунт-сила-футов}

Install the ground cables to the manual transaxle with the 2 bolts.

Момент затяжки:

8.4 Н*м{85 кгс*см, 74 фунт-сила-дюймов}

Connect the air hoses No. 2 and No. 3.

ПРИМЕЧАНИЕ:

1. Check that retainer is closed when the connector is inserted.
   
2. If replacing the hose, check for deposits in the intercooler and air hoses No. 2 and No. 3. If necessary, wipe up deposits.
   
3. If replacing the hose, apply fresh oil to the O-ring.
   
4. The connector should be inserted until a clicking sound indicating that they are completely connected is heard. Then, check that the connectors cannot be disconnected by pulling on them.
   
5. Do not use a quick connector that has been dropped.
   

Connect the vacuum transmitting hose to the No. 2 air tube.

Install the vacuum transmitting hose to the 3 clamps.

Install the battery clamp.

Момент затяжки:

for bolt:

17 Н*м{168 кгс*см, 12 фунт-сила-футов}

for nut:

3.5 Н*м{36 кгс*см, 31 фунт-сила-дюймов}

Install the 6 clips and upper radiator air deflector.

Attach the 4 clips to install the engine cover.

ПРИМЕЧАНИЕ:

1. Line up the 4 grommets using the oil filler cap and oil dipstick as guides.
   
2. Push down on the four locations shown to install the cover.