Топливная Система Common Rail -- Снятие |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY |
Disconnect the mass air flow meter connector.
 |
Disconnect the No. 2 ventilation hose.
Disconnect the 2 clamps and band, and remove the air cleaner cap sub-assembly.
Remove the air cleaner filter element.
| 3. REMOVE NO. 1 ENGINE COVER |
Detach the 4 clips and remove the engine cover.
 |
| 4. REMOVE UPPER RADIATOR AIR DEFLECTOR |
Remove the 6 clips and upper radiator air deflector.
 |
| 5. DISCONNECT ENGINE WIRE |
Remove the 2 nuts (*1).
 |
Remove the grommet and nut and disconnect the glow plug harness (*2).
Disconnect the fuel pressure sensor connector (*3).
Disconnect the turbo pressure sensor (*4).
Remove the nut (*5) and disconnect the engine wire from the engine cover bracket.
| 6. REMOVE FUEL INLET PIPE SUB-ASSEMBLY |
- ПРИМЕЧАНИЕ:
- After removing the fuel inlet pipe, cover the common rail and supply pump with electrical tape to prevent dirt from being introduced.
Remove the nut and 2 fuel inlet pipe clamps.
 |
Using the SST, remove the fuel inlet pipe.
- SST
- 09023-38401
| 7. REMOVE NO. 1 INJECTION PIPE SUB-ASSEMBLY |
Remove the 2 bolts and 4 injection pipe clamps.
 |
Using SST, loosen the nut at the common rail end of the injection pipe.
- SST
- 09023-38401
Using SST, loosen the nut at the injector end of the injection pipe.
- SST
- 09023-12701
Remove the No. 1 injection pipe sub-assembly.
| 8. REMOVE NO. 2 INJECTION PIPE SUB-ASSEMBLY |
- УКАЗАНИЕ:
- Perform the same procedure as for the No. 1 injection pipe.
| 9. REMOVE NO. 3 INJECTION PIPE SUB-ASSEMBLY |
- УКАЗАНИЕ:
- Perform the same procedure as for the No. 1 injection pipe.
| 10. REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY |
- УКАЗАНИЕ:
- Perform the same procedure as for the No. 1 injection pipe.
| 11. REMOVE COMMON RAIL ASSEMBLY |
Using pliers, slide the clip to disconnect the No. 4 fuel hose.
 |
Remove the 2 bolts and common rail assembly.