Система Механической Трансмиссии 'Multimode' Цепь Контактов Tc И Cg. Corolla ZZE150
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK HARNESS AND CONNECTOR (TCM - DLC3)
CHECK HARNESS AND CONNECTOR (CG OF DLC3 - BODY GROUND)
CHECK HARNESS AND CONNECTOR (TC OF DLC3 - BODY GROUND)
СИСТЕМА МЕХАНИЧЕСКОЙ ТРАНСМИССИИ 'MULTIMODE' - Цепь контактов TC и CG |
DESCRIPTION
Terminals TC and CG are located in the DLC3. When performing [Clamp Position Adjustment] and [Initialization and Learning] without using an intelligent tester, connecting terminals TC and CG is necessary. If the TC terminal circuit is open, these calibration procedures cannot be performed without using an intelligent tester.
WIRING DIAGRAM
INSPECTION PROCEDURE
| 1.CHECK HARNESS AND CONNECTOR (TCM - DLC3) |
Disconnect the TCM connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
| Condition
| Specified Condition
|
E33-25 (DG) - E11-13 (TC)
| Always
| Below 1 Ω
|
Reconnect the TCM connector.
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| 2.CHECK HARNESS AND CONNECTOR (CG OF DLC3 - BODY GROUND) |
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
| Condition
| Specified Condition
|
E11-4 (CG) - Body ground
| Always
| Below 1 Ω
|
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| 3.CHECK HARNESS AND CONNECTOR (TC OF DLC3 - BODY GROUND) |
Disconnect the TCM connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
| Condition
| Specified Condition
|
E11-13 (TC) - Body ground
| Always
| 10 kΩ or higher
|
Reconnect the TCM connector.
| | REPAIR OR REPLACE WIRE HARNESS OR EACH ECU |
|
|
