Задний Сальник Коленчатого Вала Установка. Corolla Auris

Apply MP grease to a new oil seal lip.

ПРИМЕЧАНИЕ:

Keep the lip free from foreign objects.

Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

SST

09223-56010

ПРИМЕЧАНИЕ:

1. Do not tap the oil seal at an angle.
   
2. Wipe off extra grease on the crankshaft.
   

Hold the crankshaft with SST.

SST

09213-58013
09330-00021

Using several steps, install and tighten 8 new bolts with a T55 "TORX" socket wrench uniformly in the sequence shown in the illustration.

Момент затяжки:

71 Н*м{724 кгс*см, 52 фунт-сила-футов}

ПРИМЕЧАНИЕ:

1. Do not reuse the flywheel installation bolts.
   
2. Be sure to check the tightening torque within 5 minutes after tightening.
   
3. Do not impact or damage the flywheel installation bolts. Be sure to handle them carefully.
   
4. Make sure there is no oil on the bolts.
   

УКАЗАНИЕ:

Make sure that the seating surface of the flywheel installation bolts and the installation surfaces of the crankshaft and flywheel are free from oil or foreign matter.

Install the clutch disk assembly for EA61 (See page Нажмите здесь).

Install the manual transaxle assembly for EA61 (See page Нажмите здесь).