Масляный Радиатор Двигателя Снятие. Corolla Auris
Двигатель. COROLLA, AURIS. ZZE150 ZRE151,152 NDE150
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
DRAIN ENGINE COOLANT
REMOVE BATTERY CLAMP SUB-ASSEMBLY
REMOVE BATTERY
REMOVE BATTERY TRAY
REMOVE BATTERY CARRIER
REMOVE NO. 1 ENGINE COVER
REMOVE RADIATOR UPPER AIR DEFLECTOR
REMOVE NO. 1 ENGINE UNDER COVER
DISCONNECT NO. 2 AIR HOSE
REMOVE NO. 1 AIR TUBE
DISCONNECT VACUUM TRANSMITTING HOSE ASSEMBLY
REMOVE NO. 3 AIR HOSE
REMOVE NO. 4 AIR HOSE
REMOVE OIL DIPSTICK GUIDE
REMOVE DIESEL THROTTLE BODY
REMOVE NO. 1 WATER BY-PASS HOSE
REMOVE OIL COOLER ASSEMBLY
REMOVE NO. 3 WATER BY-PASS PIPE
REMOVE NO. 1 TURBO OIL PIPE
REMOVE NO. 1 OIL COOLER BRACKET
Масляный Радиатор Двигателя -- Снятие |
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- ПРЕДОСТЕРЕЖЕНИЕ:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
Loosen the radiator drain cock plug.
- УКАЗАНИЕ:
- Collect the coolant in a container and dispose of it according to the regulations in your area.
Remove the radiator reservoir cap.
- ПРЕДОСТЕРЕЖЕНИЕ:
- Do not remove the radiator reservoir cap while the engine and radiator are still hot.
- Pressurized, hot engine coolant and steam may be released and cause serious burns.
Loosen the cylinder block drain cock plug.
- УКАЗАНИЕ:
- The plug is on the backside of the generator on the exhaust manifold side.
3. REMOVE BATTERY CLAMP SUB-ASSEMBLY |
Remove the bolt and loosen the nut.
Detach the hook of the battery clamp from the battery carrier, and then remove the battery clamp.
6. REMOVE BATTERY CARRIER |
Remove the 6 bolts and battery carrier.
7. REMOVE NO. 1 ENGINE COVER |
Detach the 4 clips and remove the engine cover.
8. REMOVE RADIATOR UPPER AIR DEFLECTOR |
Remove the 6 clips and upper radiator air deflector.
9. REMOVE NO. 1 ENGINE UNDER COVER |
10. DISCONNECT NO. 2 AIR HOSE |
Separate the No.2 and No.3 air hoses.
- УКАЗАНИЕ:
- Pull out the air hoses after the retainer is pulled up.
11. REMOVE NO. 1 AIR TUBE |
- УКАЗАНИЕ:
- See page Нажмите здесь for EA61
12. DISCONNECT VACUUM TRANSMITTING HOSE ASSEMBLY |
Detach the vacuum transmitting hose from the 3 clamps.
Disconnect the 2 vacuum transmitting hoses from the No. 2 air tube.
13. REMOVE NO. 3 AIR HOSE |
Remove the No. 3 air hose.
Open the retainer and remove the No. 3 air hose from the No. 2 air tube and intercooler.
14. REMOVE NO. 4 AIR HOSE |
Disconnect the sensor connector.
Remove the bolt from the No. 2 air tube.
Loosen the 2 hose clamps.
Disconnect the No. 2 air tube from the No. 4 air hose.
Remove the No. 4 air hose from the diesel throttle body.
15. REMOVE OIL DIPSTICK GUIDE |
Remove the oil dipstick.
Remove the 2 bolts, oil dipstick guide, and O-ring.
16. REMOVE DIESEL THROTTLE BODY |
Disconnect the throttle position sensor connector.
Disconnect the throttle motor connector.
Remove the 2 nuts and 2 bolts, and then remove the diesel throttle body and gasket.
17. REMOVE NO. 1 WATER BY-PASS HOSE |
Loosen the 2 clips and remove the water by-pass hose.
18. REMOVE OIL COOLER ASSEMBLY |
Disconnect the connector from the oil pressure switch.
Remove the 5 bolts, engine oil cooler, and 3 O-rings.
19. REMOVE NO. 3 WATER BY-PASS PIPE |
Remove the 2 bolts, O-ring and by-pass pipe.
20. REMOVE NO. 1 TURBO OIL PIPE |
Remove the 2 union bolts, 2 gaskets and oil pipe.
21. REMOVE NO. 1 OIL COOLER BRACKET |
Remove the 6 bolts, nut, and oil cooler bracket.
Remove the 3 O-rings.