Система Sfi Таблица Работы В Аварийном Режиме. Corolla Auris

Двигатель. COROLLA, AURIS. ZZE150 ZRE151,152 NDE150
Система Управления Двигателем 2Zr-Fe. COROLLA, AURIS. ZZE150 ZRE151,152 NDE150

Система Sfi -- Таблица Работы В Аварийном Режиме


If any of the following DTCs are set, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily.

DTC Code
Component
Fail-Safe Operation
Fail-Safe Deactivation Condition
P0011
VVT system
  1. Idling up
  2. Value timing of bank that is operating normally is fixed at maximum retard angle
Pass condition detected and then ignition switch off
P0031 and P0032
Air fuel ratio sensor heater
ECM turns off air fuel ratio sensor heater.
Ignition switch off
P0037 and P0038
Heated oxygen sensor heater
ECM turns off heated oxygen sensor heater.
Ignition switch off
P0100, P0102 and P0103
Mass air flow meter
ECM calculates ignition timing according to engine speed and throttle valve position.
Pass condition detected
P0110, P0112 and P0113
Intake air temperature sensor
ECM estimates intake air temperature to be 20°C (68°F).
Pass condition detected
P0115, P0117 and P0118
Engine coolant temperature sensor
ECM estimates engine coolant temperature sensor to be 80°C (176°F).
Pass condition detected
P0136
Heated oxygen sensor
Air fuel ratio feedback control is stopped.
Ignition switch off
P0120, P0121, P0122, P0123, P0220, P0222, P0223, P0604, P0606, P0607, P060A, P060D, P060E, P0657, P2102, P2103, P2111, P2112, P2118, P2119 and P2135
Electronic throttle control system
ECM cuts off throttle actuator current and throttle valve is returned to 6° throttle position by return spring.
ECM then adjusts engine output by controlling fuel injection (intermittent fuel-cut) and ignition timing in accordance with accelerator pedal opening angle to allow vehicle to continue at minimal speed*.
Pass condition detected and then ignition switch turned off
P0171 and P0172
Fuel trim
Air fuel ratio feedback control is stopped.
Pass condition detected and then ignition switch turned off
P0327 and P0328
Knock sensor
ECM sets ignition timing to maximum retard.
Ignition switch off
P0351, P0352, P0353 and P0354
Igniter
ECM cuts fuel.
Pass condition detected
P2120, P2121, P2122, P2123, P2125, P2127, P2128 and P2138
Accelerator pedal position sensor
Accelerator pedal position sensor has 2 sensor circuits: Main and Sub.
If either circuit malfunctions, ECM controls engine using other circuit.
If both circuits malfunction, ECM regards accelerator pedal as being released. As a result, throttle valve is closed and engine idles.
Pass condition detected and then ignition switch turned off
ПРИМЕЧАНИЕ:
*: The vehicle can be driven slowly when the accelerator pedal is depressed firmly and slowly. If the accelerator pedal is depressed quickly, the vehicle may speed up and slow down erratically.