Выпускная Труба Установка. Corolla Auris

Using vernier calipers, measure the free length of the compression springs.

УКАЗАНИЕ:

If the free length is less than minimum, replace the compression spring.

Using a plastic hammer and wooden block, tap in a new gasket until its surface is flush with the exhaust manifold converter sub-assembly.

ПРИМЕЧАНИЕ:

1. Be careful with the installation direction of the gasket.
   
2. Do not reuse the gasket.
   
3. Do not damage the gasket.
   
4. Do not push in the gasket by using the exhaust pipe when connecting it.
   

Install the exhaust pipe supports, then install the front exhaust pipe assembly with the 2 compression springs and 2 bolts.

Момент затяжки:

43 Н*м{439 кгс*см, 32 фунт-сила-футов}

Using vernier calipers, measure the free length of the compression springs.

УКАЗАНИЕ:

If the free length is less than minimum, replace the compression spring.

Using a plastic hammer and wooden block, tap in a new gasket until its surface is flush with the front exhaust pipe assembly.

ПРИМЕЧАНИЕ:

1. Be careful with the installation direction of the gasket.
   
2. Do not reuse the gasket.
   
3. Do not damage the gasket.
   
4. Do not push in the gasket by using the exhaust pipe when connecting it.
   

Install the exhaust pipe support, then install the center exhaust pipe assembly with the 2 compression springs and 2 bolts.

Момент затяжки:

43 Н*м{439 кгс*см, 32 фунт-сила-футов}

Install a new exhaust pipe gasket.

Install the exhaust pipe support, then install the tail exhaust pipe assembly with the 2 bolts.

Момент затяжки:

43 Н*м{439 кгс*см, 32 фунт-сила-футов}

ПРИМЕЧАНИЕ:

1. Do not reuse the gasket.
   
2. Do not damage the gasket.
   

Check that there are no exhaust gas leaks from the points (jointed parts of the exhaust pipes and installed parts of each sensor) shown in the illustration.