Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1UR-FE ENGINE MECHANICAL
CYLINDER BLOCK - REPLACEMENT
| 1. REPLACE STRAIGHT PIN |
- NOTICE:
- It is not necessary to remove a straight pin unless it is being replaced.
| *1 | Height | *2 | Width |
| *3 | Protrusion Height | - | - |
| *a | Upper Side | *b | Lower Side |
| *c | Front | *d | Rear |
Remove the straight pins.
Using a plastic-faced hammer, tap in new straight pins to the cylinder block.
- Standard Straight Pin:
Item Height Width Protrusion Pin A 36 mm (1.42 in.) 10 mm (0.394 in.) 22 to 24 mm (0.866 to 0.945 in.) Pin B 22 mm (0.866 in.) 10 mm (0.394 in.) 10.5 to 11.5 mm (0.413 to 0.453 in.) Pin C 18 mm (0.709 in.) 8 mm (0.315 in.) 8.0 to 10.0 mm (0.315 to 0.394 in.) Pin D 12 mm (0.472 in.) 4 mm (0.157 in.) 5.0 to 7.0 mm (0.197 to 0.276 in.)