Side Monitor System - How To Proceed With Troubleshooting
SIDE MONITOR SYSTEM - HOW TO PROCEED WITH TROUBLESHOOTING
Use the following procedure to troubleshoot the side monitor system.
*: Use the intelligent tester.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| 2.INSPECT BATTERY VOLTAGE |
Measure the voltage with the ignition switch off.
- Standard voltage:
- 11 to 14 V
If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.
| 3.CHECK NAVIGATION SYSTEM |
Refer to the navigation system ().
Result| Result | Proceed to |
| Navigation system is normal | A |
| Navigation system is abnormal | B |
| | Go to NAVIGATION SYSTEM () |
|
|
| 4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Use the intelligent tester to check if the CAN communication system is functioning normally.
Result| Result | Proceed to |
| CAN DTC is not output | A |
| CAN DTC is output (for LHD) | B |
| CAN DTC is output (for RHD) | C |
| | Go to CAN COMMUNICATION SYSTEM () |
|
| | Go to CAN COMMUNICATION SYSTEM () |
|
|
Check for DTCs and note any codes that are output ().
Check for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.
- The parking assist ECU may store the DTCs of the following system. If DTCs other than those specified in Diagnostic Trouble Code Chart of the side monitor system are output, refer to Diagnostic Trouble Code Chart for the applicable system.
| System | Proceed to |
| Parking Assist Monitor System (w/ Side Monitor System) |
|
| Wide View Front Monitor System |
|
Result| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
Refer to the Problem Symptoms Table ().
Result| Result | Proceed to |
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
| | ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE |
|
|
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING |
| 8.ADJUST, REPAIR OR REPLACE |