Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - BRAKE FRONT
FRONT BRAKE - REMOVAL
- HINT:
Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
| 1. REMOVE FRONT WHEEL |
| 2. DRAIN BRAKE FLUID |
- NOTICE:
- Wash brake fluid off immediately if it is spilled on any painted surface.
| 3. REMOVE FRONT DISC BRAKE PAD |
Remove the pin hold clip.
- NOTICE:
- The pin hold clip can be reused if it has sufficient rebound; no deformation or wear; and has had all rust, dirt and foreign particles cleaned off.
Remove the 2 hole pins.
Remove the front disc brake anti-rattle spring.
- NOTICE:
- The anti-rattle spring can be reused if it has sufficient rebound; no deformation, cracks or wear; and has had all rust, dirt and foreign particles cleaned off.
Remove the 2 pads from the disc brake caliper.
Remove the No. 1 anti-squeal shims from each pad.
| 4. DISCONNECT FRONT FLEXIBLE HOSE |
Remove the union bolt and gasket, and then disconnect the flexible hose.
| 5. REMOVE DISC BRAKE CALIPER ASSEMBLY LH |
Remove the 2 bolts and disc brake caliper from the knuckle.
| 6. REMOVE FRONT DISC |
Put matchmarks on the front disc and axle hub if planning to reuse the disc.
Remove the front disc.