Dtc C1268 Transfer L4 Position Switch Circuit

Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS

DESCRIPTION

INSPECTION PROCEDURE

INSPECT TRANSFER L4 SHIFT

RECONFIRM DTC

DTC C1268 Transfer L4 Position Switch Circuit

DESCRIPTION

DTC CodeDTC Detection ConditionTrouble Area
C1268The skid control ECU receives an L4 abnormal status signal from the four wheel drive control ECU via CAN communication for 2 seconds or more.
Transfer system
Skid control ECU (Master cylinder solenoid)

INSPECTION PROCEDURE

  • NOTICE:
  • After replacing the master cylinder solenoid, perform zero point calibration and store the system information ().
1.INSPECT TRANSFER L4 SHIFT

Shift the transfer to L4, and then drive the vehicle and check that there are no problems with the transfer system.

  • OK:
  • There are no problems with the transfer system.
NG
GO TO TRANSFER SYSTEM (PROBLEM SYMPTOMS TABLE) ()
OK
2.RECONFIRM DTC

Clear the DTCs ().

Turn the ignition switch off.

Shift the transfer to L4, drive the vehicle, and then check for DTCs ().

Result
ResultProceed to
DTC is not outputA
DTC is output (for LHD)B
DTC is output (for RHD)C
B
REPLACE MASTER CYLINDER SOLENOID ()
C
REPLACE MASTER CYLINDER SOLENOID ()
A
CHECK FOR INTERMITTENT PROBLEMS ()