Генератор Снятие. Corolla Auris

Двигатель. COROLLA, AURIS. ZZE150 ZRE151,152 NDE150
Система Зарядки 2Ad-Fhv. COROLLA, AURIS. ZZE150 ZRE151,152 NDE150

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE NO. 1 ENGINE COVER

  3. REMOVE RADIATOR UPPER AIR DEFLECTOR

  4. REMOVE NO. 1 ENGINE UNDER COVER

  5. REMOVE ENGINE UNDER COVER REAR RH

  6. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH

  7. REMOVE V-RIBBED BELT

  8. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH

  9. REMOVE GENERATOR ASSEMBLY

Генератор -- Снятие



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE NO. 1 ENGINE COVER


    COROLLA, AURIS. ZZE150 ZRE151,152 NDE150.Система Зарядки 2Ad-Fhv.Система Зарядки.Генератор Снятие

  1. Detach the 4 clips and remove the engine cover.

    ПРИМЕЧАНИЕ:
    1. Lift the area around the clips on the top of the engine cover.
    2. Do not suddenly lift the engine cover. Remove the cover slowly by detaching the clips on by one.
    3. Lift area A shown in the illustration particularly slowly because there is a cowl on the top of the area around A. Failure to do so may damage the cover.


3. REMOVE RADIATOR UPPER AIR DEFLECTOR


    COROLLA, AURIS. ZZE150 ZRE151,152 NDE150

  1. Remove the 6 clips and upper radiator air deflector.



4. REMOVE NO. 1 ENGINE UNDER COVER


5. REMOVE ENGINE UNDER COVER REAR RH


6. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH


    COROLLA, AURIS. ZZE150 ZRE151,152 NDE150

  1. Выверните 4 болта и снимите правое усиление элемента передней подвески.



7. REMOVE V-RIBBED BELT


    COROLLA, AURIS. ZZE150 ZRE151,152 NDE150.Система Зарядки 2Ad-Fhv.Система Зарядки.Генератор Снятие

  1. Using SST and a 22 mm wrench, rotate the tensioner pulley counterclockwise to loosen the belt tension. Then remove the belt.

    SST
    09216-42010
    ПРИМЕЧАНИЕ:
    Make sure that SST is installed as shown in the illustration. If not, SST and/or the belt may not be able to be removed.
    ПРЕДОСТЕРЕЖЕНИЕ:
    1. Be careful as the wrench only fits loosely on the belt tensioner tool set point. The wrench may come off the set point and cause injuries.
    2. Be careful that your hands do not become jammed between parts such as the belt, pulleys, etc.


8. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
(See page Нажмите здесь)


9. REMOVE GENERATOR ASSEMBLY


    COROLLA, AURIS. ZZE150 ZRE151,152 NDE150

  1. Disconnect the generator connector.

  1. Remove the terminal cap.

  1. Remove the nut and bolt, and disconnect the generator wire from terminal B.

  1. Remove the 3 bolts and generator assembly.