Генератор Установка. Corolla Auris

Install the generator assembly with the 3 bolts.

Момент затяжки:

25 Н*м{255 кгс*см, 18 фунт-сила-футов}

ПРИМЕЧАНИЕ:

Make sure that the wire harness of the crankshaft position sensor does not get caught between the cylinder block and the generator assembly when installing the generator assembly.

Connect the generator wire to terminal B with the nut and bolt.

Момент затяжки:

for Nut:

9.8 Н*м{100 кгс*см, 87 фунт-сила-дюймов}

for Bolt:

7.7 Н*м{79 кгс*см, 68 фунт-сила-дюймов}

Install the terminal cap.

Connect the generator connector.

Using SST and a 22 mm wrench, rotate the tensioner pulley counterclockwise, and then install the V-ribbed belt.

SST

09216-42010

ПРИМЕЧАНИЕ:

1. Make sure that the belt is set properly at each pulley.
   
2. Make sure SST is installed as shown in the illustration. If not, SST and/or the belt may not be able to be removed.
   

ПРЕДОСТЕРЕЖЕНИЕ:

1. Be careful as the wrench only fits loosely on the belt tensioner tool set point. The wrench may come off the set point and cause injuries.
   
2. Be careful that your hands do not become jammed between parts such as the belt, pulleys, etc.
   

Установите правое усиление элемента передней подвески и закрепите его 4 болтами.

Момент затяжки:

96 Н*м{979 кгс*см, 71 фунт-сила-футов}

ПРИМЕЧАНИЕ:

Предварительно затяните болты A и B, а затем полностью затяните 4 болта в следующем порядке: C, B, D и A.

Install the 6 clips and upper radiator air deflector.

Attach the 4 clips to install the engine cover.