Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - JF2A TRANSFER / 4WD / AWD
TRANSFER OIL - ON-VEHICLE INSPECTION
| 1. CHECK TRANSFER OIL |
Remove the filler plug and gasket.
Check that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the filler plug hole.
If the result is not as specified, add transfer oil.
- Viscosity:
- SAE 75W
- Standard Capacity:
- 1.4 to 1.5 liters (1.5 to 1.6 US qts, 1.2 to 1.3 Imp. qts)
- NOTICE:
- Too much or too little oil will lead to transfer problems.
When the oil level is too low, check for oil leaks.
Install a new gasket onto the filler plug and then tighten the plug.
- Torque:
- 37 N*m{ 377 kgf*cm, 27 ft.*lbf}
| 2. ADD TRANSFER OIL |
Remove the filler plug and gasket.
Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the filler plug hole.
- NOTICE:
Add oil slowly.
Add oil a little at a time, waiting several minutes between each addition of oil.
Wait approximately 5 minutes and check that the oil level has not changed.
Install a new gasket onto the filler plug and then tighten the plug.
- Torque:
- 37 N*m{ 377 kgf*cm, 27 ft.*lbf}