Occupant Detection Sensor (For Power Seat) Installation

Using hog ring pliers, install the separate type front seat cushion cover to the seat cushion pad with new hog rings.

NOTICE:

1. Be careful not to damage the cover.
   
2. When installing the hog rings, take care to minimize wrinkles as much as possible.
   

Connect the hooks to install the separate type front seat cushion cover with pad.

Install the 2 clips.

Engage the clamp to install the occupant detection sensor connector.

Connect the connectors and clamps.

Connect the 2 connectors.

Install the switch with the 3 screws.

Connect the connector.

Install the switch with the 3 screws.

Attach the clip and 2 claws to install the cushion shield inner.

Install the screw.

Connect the connector to the lumbar front power seat switch.

Attach the claw and install the cushion shield with cushion shield inner.

Install the 5 screws.

Install the 2 rubber bands of the front seatback board to the seat frame.

Connect the connector to the No. 1 interior illumination light.

Install the front seat inner belt assembly with the nut.

Torque:

42 N*m{428 kgf*cm, 31 ft.*lbf}

NOTICE:

Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding parts of the front seat adjuster.

Connect the connector and attach the 4 clamps.

Place the seat in the cabin.

Connect the connectors under the seat.

Connect the cable to the negative (-) battery terminal.

Operate the power seat switch knob and move the seat to the position farthest forward.

Tighten the 2 bolts on the rear seat track bracket.

Torque:

37 N*m{377 kgf*cm, 27 ft.*lbf}

HINT:

Tighten the 2 bolts in the order indicated in the illustration.

Operate the power seat switch knob and move the seat to the rearmost position.

Tighten the 2 bolts on the rear seat track bracket.

Torque:

37 N*m{377 kgf*cm, 27 ft.*lbf}