Center Airbag Sensor Assembly Installation

Check that the engine switch is off.

Check that the battery negative (-) terminal is disconnected.

NOTICE:

After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.

Install the center airbag sensor assembly with the nut and 2 bolts.

Torque:

17.5 N*m{179 kgf*cm, 13 ft.*lbf}

NOTICE:

1. If the center airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
   
2. When installing the center airbag sensor assembly, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
   

Check that there is no looseness in the installation parts of the center airbag sensor assembly.

Connect the holder (with connectors).

Check that the water-proof sheet is properly set.

Engage the 2 claws and 2 clips.

Install the 2 bolts <C>.

Install the 2 bolts <C>.

Connect the connector.

Connect the connectors.

Engage the 2 clamps.

Install the 2 bolts <C>.

Engage the 2 claws and 4 clips, and then install the console box register assembly.

Install the rear ash receptacle assembly.

Engage the 6 clips.

Close the snap.

Engage the 6 clips.

Close the snap.

Engage the 7 claws and 2 clips.

Close the snap.

Connect the connectors.

Engage the 8 clips and install the console panel sub-assembly.

Engage the claw and 2 clips, and then install the upper No. 2 console panel garnish.

Engage the claw and 2 clips, and then install the upper No. 1 console panel garnish.

Perform initialization (Click here).

HINT:

Some systems need initialization after reconnecting the cable to the negative battery terminal.

Inspect the SRS warning light (Click here).