Vehicle Stability Control System (W/ Vdim) Diagnosis System

Brake. Lexus Is250, Is220D. Gse20 Ale20
Brake Control. Lexus Is250, Is220D. Gse20 Ale20
  1. DIAGNOSIS

  1. WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK

Vehicle Stability Control System (W/ Vdim) -- Diagnosis System



DIAGNOSIS


    Lexus Is250, Is220D. Gse20 Ale20.Brake Control.Vehicle Stability Control System (W/ Vdim).Vehicle Stability Control System (W/ Vdim)  Diagnosis System
  1. If the skid control ECU detects a malfunction, the ABS warning, BRAKE warning, master caution indicator, and SLIP indicator lights will come on and the multi information display shows warning messages, in order to warn the driver.
    The table below indicates which lights will come on when there is a malfunction in a particular function.

    Item / Trouble Area
    ABS
    EBD
    BA
    TRC
    VSC
    ABS warning light



    -
    -
    BRAKE warning light
    -

    -
    -
    -
    VSC warning (multi information display and master caution indicator light) light





    SLIP indicator light





    ○: Light ON
    -: Light OFF
    1. The DTCs are simultaneously stored in the memory. The DTCs can be read by connecting the SST between terminals TC and CG of the DLC3 and observing the blinking pattern of the ABS warning light or multi information display, by reading the multi information display, or by connecting the intelligent tester.
    2. This system has a signal check function (Click here).
      The DTC can be read by connecting the intelligent tester and observing the blinking pattern of the ABS warning light or by reading the multi information display.

WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK


    Lexus Is250, Is220D. Gse20 Ale20.Brake Control.Vehicle Stability Control System (W/ Vdim).Vehicle Stability Control System (W/ Vdim)  Diagnosis System
  1. Release the parking brake.

    NOTICE:
    When releasing the parking brake, set chocks to hold the vehicle for safety.
    HINT:
    When the parking brake is applied or the level of the brake fluid is low, the BRAKE warning light comes on.
  2. When the engine switch is turned on (IG), check that the ABS warning, BRAKE warning, master caution indicator, and SLIP indicator lights come on for approximately 3 seconds. Make sure that the message on the multi information display changes from "CHECK" to "COMPLETE" for 2 seconds.

    HINT:
    If the warning light and indicator light check result is not normal, proceed to troubleshooting for the ABS, BRAKE and VSC warning light circuits and SLIP indicator light circuit.
    If the indicator remains on, proceed to troubleshooting for the light circuit below.
    Trouble Area
    See procedure
    ABS warning light circuit
    Click here
    BRAKE warning light circuit
    Click here
    VSC warning light circuit
    Click here
    SLIP indicator light circuit
    Click here