Extension Housing Rear Oil Seal Removal

Remove the drain plug and gasket, and drain the ATF.

Install a new gasket and the drain plug.

Torque:

20 N*m{204 kgf*cm, 15 ft.*lbf}

Remove the grommets of the heated oxygen sensors (BANK 1, BANK 2).

Using the SST, remove a oxygen sensors (BANK 1, BANK 2).

SST

09224-00010

Remove the 4 bolts and rear No. 1 floor panel brace.

Remove the 4 bolts and front center floor brace .

Remove the 4 bolts and 4 nuts.

Remove the 2 bolts and 2 compression springs from the tail exhaust pipe assembly.

Remove the front exhaust pipe assembly and 3 gaskets.

Remove the 4 nuts and front No. 1 floor heat insulator.

Remove the 4 nuts and outside air guide plate RH.

Put matchmarks on both flanges.

Remove the 4 nuts, bolts and washers.

HINT:

If the flange connection is hard to separate, temporarily tighten one nut only and evenly tap the flange with a brass bar and hammer to separate the propeller shaft assembly from the differential companion flange.

Remove the 2 bolts and 2 center support bearing washers. (for automatic transmission)

Remove the 2 bolts, 2 center support bearing washers and 2 center support bearing dampers. (for manual transmission)

Separate the center support bearing.

Insert SST in the transmission to prevent oil leakage.

SST

09325-40010

NOTICE:

Be careful not to damage the oil seal.

Using SST, remove the oil seal.

SST

09308-00010