Air Fuel Ratio Sensor Installation

Using SST, install the air fuel ratio sensor.

SST

09224-00010

Torque:

44 N*m{449 kgf*cm, 32 ft.*lbf}

Connect the air fuel ratio sensor connector.

Install the front floor cover RH.

Check the degree of tilt when the ELR begins to lock.

1. Check that the belt does not lock at less than 15 degrees of tilt in any direction but locks at over 45 degrees of tilt while gently pulling the belt.
   

   NOTICE:

   Do not disassemble the retractor.

Temporarily install the front seat outer belt assembly with the 2 bolts.

Fully tighten the upper side bolt first, then the lower side bolt to install the front seat outer belt assembly.

Torque:

For upper bolt:

7.5 N*m{77 kgf*cm, 66 in.*lbf}

For lower bolt:

42 N*m{428 kgf*cm, 31 ft.*lbf}

Connect the pretensioner connector and lock the locking button as shown in the illustration.

NOTICE:

Securely lock the locking button.

Connect the connectors.

Install the shoulder anchor of the front seat outer belt assembly with the nut.

Torque:

42 N*m{428 kgf*cm, 31 ft.*lbf}

Engage the 3 claws to install the lap belt outer anchor cover.