Engine Rear Oil Seal Installation

Apply MP grease to a new oil seal lip.

NOTICE:

Keep the lip free from foreign objects.

Using SST and a hammer, tap in the oil seal until its surface is flush with the edge of the rear oil seal retainer.

SST

09223-56010

NOTICE:

1. Do not tap the oil seal at an angle.
   
2. Wipe off extra grease on the crankshaft.
   

Hold the crankshaft with SST.

SST

09213-58013
09330-00021

Install and tighten 8 new bolts a little at a time uniformly in the sequence shown in the illustration.

Torque:

73 N*m{741 kgf*cm, 54 ft.*lbf}

HINT:

1. Do not reuse the flywheel installation bolts.
   Be sure to check the tightening torque within 5 minutes after tightening.
   
2. Do not impact or damage the flywheel installation bolts. Be sure to handle them carefully.
   
3. Make sure that the seating surface of the flywheel installation bolts and installation surfaces of the crankshaft and flywheel are free of oil or foreign matter.