Engine Front Oil Seal Removal
Engine. Lexus Is250, Is220D. Gse20 Ale20
REMOVE COOL AIR INTAKE DUCT SEAL
REMOVE NO. 1 INLET AIR CLEANER
REMOVE NO. 1 ENGINE COVER
REMOVE V-RIBBED BELT
REMOVE RADIATOR ASSEMBLY
REMOVE CRANKSHAFT PULLEY
REMOVE TIMING CHAIN CASE OIL SEAL
Engine Front Oil Seal -- Removal |
| 1. REMOVE COOL AIR INTAKE DUCT SEAL |
Remove the 11 clips and intake duct seal.
| 2. REMOVE NO. 1 INLET AIR CLEANER |
Remove the bolt, clip and inlet air cleaner.
| 3. REMOVE NO. 1 ENGINE COVER |
Remove the No. 1 engine cover.
Release the belt tension by turning the belt tensioner counterclockwise, and remove the V-ribbed belt from the belt tensioner.
While turning the belt tensioner counterclockwise, align its holes, and then insert a 5 mm (0.20 in.) bar into the holes to hold the belt tensioner.
| 5. REMOVE RADIATOR ASSEMBLY |
Click here.
| 6. REMOVE CRANKSHAFT PULLEY |
Remove the bolt while holding the crankshaft with SST.
- SST
- 09213-58013
09330-00021
- Recommended service bolt:
Item
| Specified Condition
|
Thread diameter
| 12 mm (0.47 in.)
|
Thread pitch
| 1.5 mm (0.059 in.)
|
Bolt length
| Approx. 30 to 38 mm (1.18 to 1.50 in.)
|
Remove the crankshaft pulley with SST.
- SST
- 09950-50013(09951-05010,09952-05010,09953-05020,09954-05021)
| 7. REMOVE TIMING CHAIN CASE OIL SEAL |
Using a knife, cut off the oil seal lip.
Using a screwdriver with the tip taped, pry out the oil seal.
- HINT:
- Tape the screwdriver tip before use.
- NOTICE:
- After removing the oil seal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.
