Center Power Outlet Socket Removal
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE FRONT CONSOLE UPPER PANEL GARNISH
REMOVE CONSOLE UPPER PANEL ASSEMBLY
REMOVE INSTRUMENT PANEL FINISH PANEL END RH
REMOVE INSTRUMENT PANEL FINISH PANEL END LH
REMOVE CONSOLE BOX PLATE
REMOVE CONSOLE BOX REGISTER ASSEMBLY
REMOVE CONSOLE BOX
REMOVE REAR CONSOLE ARMREST ASSEMBLY
REMOVE CONSOLE BOX SUB-ASSEMBLY UPPER
REMOVE POWER OUTLET SOCKET ASSEMBLY
Center Power Outlet Socket -- Removal |
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE FRONT CONSOLE UPPER PANEL GARNISH |
Using a clip remover, detach the claws and remove the garnish.
- HINT:
- Tape the clip remover tip before use.
3. REMOVE CONSOLE UPPER PANEL ASSEMBLY |
Twist the shift lever knob in the direction indicated by the arrow and remove it.
Using a screwdriver, detach the 9 clips.
- HINT:
- Tape the screwdriver tip before use.
Remove the ash receptacle and then disconnect the connector.
4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH |
Remove the screw.
Using a screwdriver, detach the 3 clips and 3 claws.
- HINT:
- Tape the screwdriver tip before use.
Remove the finish panel end.
5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH |
Remove the screw.
Using a screwdriver, detach the 4 clips and 3 claws.
- HINT:
- Tape the screwdriver tip before use.
Remove the finish panel end.
6. REMOVE CONSOLE BOX PLATE |
Using a screwdriver, detach the 4 clips.
- HINT:
- Tape the screwdriver tip before use.
Remove the console box plate and then disconnect the connector.
7. REMOVE CONSOLE BOX REGISTER ASSEMBLY |
Using a screwdriver, detach the 4 clips and remove the register.
- HINT:
- Tape the screwdriver tip before use.
Remove the 4 bolts and 2 screws.
Remove the console box and then disconnect the connector.
9. REMOVE REAR CONSOLE ARMREST ASSEMBLY |
Remove the 4 screws.
Remove the rear console armrest, as shown in the illustration.
10. REMOVE CONSOLE BOX SUB-ASSEMBLY UPPER |
Remove the console box as shown in the illustration.
11. REMOVE POWER OUTLET SOCKET ASSEMBLY |
Rotate the socket to disengage the notch.
Pull out the socket halfway and rotate the socket until its protrusion is aligned with the groove of the cover.
Remove the socket from the cover.