Navigation System Stereo Component Amplifier Power Source Circuit
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
INSPECT FUSE (RAD NO. 1, RAD NO. 2, ACC)
CHECK WIRE HARNESS (STEREO COMPONENT AMPLIFIER - BATTERY AND BODY GROUND)
NAVIGATION SYSTEM - Stereo Component Amplifier Power Source Circuit |
DESCRIPTION
This circuit provides the power to the stereo component amplifier.
WIRING DIAGRAM
INSPECTION PROCEDURE
1.INSPECT FUSE (RAD NO. 1, RAD NO. 2, ACC) |
Remove the RAD NO. 1 and RAD NO. 2 fuses from the engine room No. 1 relay block.
Remove the ACC fuse from the cowl side junction block RH.
Measure the resistance of the fuses.
- Standard resistance:
- Below 1 Ω
2.CHECK WIRE HARNESS (STEREO COMPONENT AMPLIFIER - BATTERY AND BODY GROUND) |
Disconnect the V29 and V31 amplifier connectors.
Measure the voltage of the wire harness side connectors.
- Standard voltage:
Tester Connection
| Condition
| Specified Condition
|
V31-1 (+B) - Body ground
| Always
| 10 to 14 V
|
V31-10 (+B2) - Body ground
| Always
| 10 to 14 V
|
V29-12 (ACC) - Body ground
| Engine switch on (ACC)
| 10 to 14 V
|
Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection
| Condition
| Specified Condition
|
V31-16 (GND) - Body ground
| Always
| Below 1 Ω
|
V31-15 (GND2) - Body ground
| Always
| Below 1 Ω
|
| REPAIR OR REPLACE HARNESS AND CONNECTOR |
|
|
OK |
|
|
|
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE |
|