Audio And Visual System Sound Signal Circuit Between Radio Receiver And Stereo Component Amplifier
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK WIRE HARNESS (RADIO RECEIVER - STEREO COMPONENT AMPLIFIER)
AUDIO AND VISUAL SYSTEM - Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier |
DESCRIPTION
The radio receiver assembly sends a sound signal to the stereo component amplifier through this circuit. The sound signal that is sent is amplified by the stereo component amplifier, and then is sent to the speaker. If there is an open or short in the circuit, sound cannot be heard from the speaker even if there is no malfunction in the stereo component amplifier or speaker.
WIRING DIAGRAM
INSPECTION PROCEDURE
| 1.CHECK WIRE HARNESS (RADIO RECEIVER - STEREO COMPONENT AMPLIFIER) |
Disconnect the L54 radio receiver assembly and V29 stereo component amplifier connectors.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
| Specified Condition
|
V29-3 (L+) - L54-9 (L+)
| Below 1 Ω
|
V29-2 (L-) - L54-19 (L-)
| Below 1 Ω
|
V29-5 (R+) - L54-8 (R+)
| Below 1 Ω
|
V29-4 (R-) - L54-18 (R-)
| Below 1 Ω
|
V29-3 (L+) - Body ground
| 10 kΩ or higher
|
V29-2 (L-) - Body ground
| 10 kΩ or higher
|
V29-5 (R+) - Body ground
| 10 kΩ or higher
|
V29-4 (R-) - Body ground
| 10 kΩ or higher
|
L54-9 (L+) - Body ground
| 10 kΩ or higher
|
L54-19 (L-) - Body ground
| 10 kΩ or higher
|
L54-8 (R+) - Body ground
| 10 kΩ or higher
|
L54-18 (R-) - Body ground
| 10 kΩ or higher
|
| | REPAIR OR REPLACE HARNESS AND CONNECTOR |
|
|
| OK |
|
|
|
| PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE |
|
